2.2.1 Single LED Blinking

Hello Readers:

I have started this blog to show you Embedded C programming for 8051 family microcontroller using KEIL compiler. The KISS philosophy is used to write this tutorial. What is KISS? Keep It Simple, Stupid!

2. Manipulating Port Pins

This section teaches you how to manipulate port pins bytewise and bitwise.

2.2 Bitwise [single bit]

Now we see how to control port pins bitwise.

2.2.1   Single LED Blinking

This program blinks single LED and thus shows how to manipulate single bit of microcontroller chip.

Start KEIL V4.01 and close projects, if any are open. Now start new project with Device -> Generic->8051 [all variants] for general 8051 family target chip. Add a new text file, name it Pgm_221.C and add it to above created project as a source file. It is time to add code to Pgm_222.C, so type below shown code in it.

Code explanation:

Line 05: Declaring single bit [0^th bit] of Port 2 using sbit key word.

Line 11: Initializing Port 2 to 0x00.

Line 13: This statement creates infinite loop.

Line 15: Making LED connected to Port 2 pin 0 HIGH.

Line 16: 250 MilliSecond Delay.

Line 17: Making LED connected to Port 2 pin 0 LOW.

Line 18: 250 MilliSecond Delay.

Below is the flow chart diagram of program PGM_221.C.

 

 

After typing the code, press F7 or click Project->Build Target for building the source code. If there are no typical errors file will build successively and shows zero errors and zero warnings.

Now enter into debug mode by pressing Ctrl+F5 or click Debug->Start/Stop Debug Session menu. Our program is making/toggling LED connected to Port 2-pin 0 continuously by sending 0 & 1 repeatedly. So we want to watch the Port 2 0^th pin while running this program for changing values. To get Port 2 tab click Peripherals->I/O Ports->Port 2 menu.

Run the program by pressing F5 or clicking Debug->Run. You can see the Port 2 0^th pin toggles continuously. If you generate HEX file of this program, burn it into your target chip’s memory using suitable uploader and connecting an LED to 0^th pin of Port 2 you can watch LED blinking. To stop running the program press red ‘x’ mark icon or click Debug->Stop.

To get back the compile mode press Ctrl+F5 or click Debug->Start/Stop Debug Session menu.   

<End of 2.2.1 Single LED Blinking >

...till next post bye-bye & take care.