2.1.5 Toggling Port Pins

Hello Readers:

I have started this blog to show you Embedded C programming for 8051 family microcontroller using KEIL compiler. The KISS philosophy is used to write this tutorial. What is KISS? Keep It Simple, Stupid!

2. Manipulating Port Pins

This section teaches you how to manipulate port pins bytewise and bitwise.

2.1 Bytewise [all port pins-8bits]

First we see how to control port pins bytewise.

2.1.5 Toggling Port Pins

This program teaches you how to send byte data to any Input/Output ports. Here 0101 0101 and 1010 1010 are sending to Port 2. That means we are toggling Port 2 pins with values 0x55 and 0xAA. 

Start KEIL V4.01 and close projects, if any are open. Now start new project with Device -> Generic->8051 [all variants] for general 8051 family target chip. Add a new text file, name it Pgm_215.C and add it to above created project as a source file. It is time to add code to Pgm_215.C, so type below shown code in it.

Code explanation:

Line 10: This statement creates infinite loop as its all conditions are empty. This is necessary as 8051 is not having any Operating System and it never exits.

Line 12: The 0101 0101 or 0x55 [in hex] value is sent to Port 2.

Line 13: The 250 MilliSecond Delay.

Line 14: The 1010 1010 or 0xAA [in hex] value is sent to Port 2.

Line 15: The 250 MilliSecond Delay.

Below is the flow chart diagram of program PGM_215.C.

After typing the code, press F7 or click Project->Build Target for building the source code. If there are no typical errors file will build successively and shows zero errors and zero warnings.

Now enter into debug mode by pressing Ctrl+F5 or click Debug->Start/Stop Debug Session menu. Our program is toggling 0x55 and 0xAA numbers in binary form to Port 2 continuously. So we want to watch the Port 2 pins while running this program for toggling values. To get Port 2 tab click Peripherals->I/O Ports->Port 2 menu.

Run the program by pressing F5 or clicking Debug->Run. You can see the toggling values between 0x55 and 0xAA on Port 2 tab continuously in binary form. If you generate HEX file of this program, burn it into your target chip’s memory using suitable uploader and connecting 8 LEDs to Port 2 you can watch LEDs toggling in binary form. To stop running the program press red ‘x’ mark icon or click Debug->Stop.

To get back the compile mode press Ctrl+F5 or click Debug->Start/Stop Debug Session menu.   

<End of 2.1.5 Toggling Port Pins >

...till next post bye-bye & take care.